Compare Air Conditioner Brands and Install a Window-Mounted Air Conditioner

Compare air conditioner brands before you make a final decision to make sure you find the air conditioner that best suits your needs. By taking the time to compare air conditioner brands, you will find information that will allow you to buy a quality air conditioner within your budget. Look at the Seasonal Energy Efficient Rating SEER for each air conditioner brand.

How to Compare Air Conditioner Brands

This rating will range from 13 to 2The higher the SEER number, the higher the efficiency of the air conditioner. Examine the features of each air conditioner brand. Some brands offer features that arent really necessary like a remote control, but come standard, so they add to the overall cost of the air conditioner.

Find out what type of refrigerant is used. Refrigerants such as Freon, deplete the ozone layer. Manufacturers must phase out the use of Freon by law.

Look for the refrigerant Puron, which is EPA-approved and wont make your air conditioner obsolete after you buy it. Check the parts and labor warranties. Air conditioners are expensive to fix.

Read also:   Pressure Wash and Clean Window Unit Air Conditioners and Discharge an Air Conditioner Capacitor

Checking the warranty to ensure that your parts and labor are covered for an extended period of time usually 10 years and 5 years, respectively will save you from paying an expensive repair bill in the future. Get the Energy Star rating. Air conditioner brands that are not Energy Star rated are considerably more expensive to operate than those that arent.

How to Install a Window-Mounted Air Conditioner

Window air conditioners have energy efficiency ratio ratings EER. Higher the EER ratings correspond to higher energy efficiency. Window air conditioners built after January 1,1990 must have an EER rating of 8.

0 or higher. Open the window. Measure the window opening and the air conditioners case with a tape measure.

Compare the two sets of measurements to verify that the air conditioner will fit in the window. Inspect the window opening. The window frame must have solid construction.

Replace any rotten wood and secure all loose building materials. Verify that nothing on the outside will interfere with the air conditioners air flow out the rear of the unit. Find the center of the window sill with a tape measure and mark it with a pencil.

Read also:   Clean a Home Air Conditioner Filter and Recharge Air Conditioning with Freon in a Plymouth Neon

Layout the mounting brackets using the center line as a guide. Modern window air conditioners come with a bracket template. Line up the center of the template with the center line and mark the screw holes on the window sill using the template as a guide.

For older window units, install the brackets 1 inch in from the outside edges. Using the center line as a guide, mark the spot where the outside edges of the air conditioner will line up, then layout the brackets screw holes 1 inch inside of that mark. Drill pilot holes in the window sill with a drill.

If the window sill is wood, use a 1/8-inch drill bit for the pilot holes. Use an anchor kit for concrete window sills. The anchor kit will supply the proper size masonry drill bit.

After using the masonry bit, push the anchors into the holes. Softly tap tight-fitting anchors with a hammer to set them in place.

Read also:   Remove Yellow Jackets From an Air Conditioner and Clean Air Conditioner Fins

Installing a properly sized window air conditioning unit will remove humidity and control air temperature in the selected room. In general, a 1 ton, 12000 British thermal units BTU, air conditioner will cool a 500-square-foot room. While less efficient than central heat and air conditioning systems, window units generally cost less to run.

Leave a Reply

Your email address will not be published. Required fields are marked *