Menu

Use Auto 12-Volt Regulator for Solar Panel

If you use solar energy to plan on a large scale, you will be a battery bank of deep cycle 12 volt batteries need. To fully charged to keep your battery bank and function optimally, you need to install charge controller between solar panel array and battery bank. Without charge controller, batteries could overcharge.

overboost depletes battery life and cause batteries to leak or even explode. Make sure to install your solar power system with this simple mechanism. Find charge controller, the correct specification for your solar panel array has.

Use Auto 12-Volt Regulator for Solar Panel

charge controller must be able to handle amperage load of your solar array. In many cases 45-amp charge controller with 50-amp fuse will be sufficient, however it is best not to leave it to chance. Consult electrical professional or detailed guidebook on constructing solar energy generators.

You can purchase charge controllers from variety of online retailers as well as local electronic parts stores. Connect charge controller to your system between solar panel array and battery bank. Depending on gauge of existing wiring, you may solder it in place or use nuts and bolts to clamp wires together.

Set charge controller to turn electrical current from solar panels on when charge of battery bank drops below 11.7 volts and to shut current off when charge of batteries exceeds 14.3 volts. Allow solar array to charge your battery bank normally. Once system is charged, you are ready to safely use electricity you have stored.

We hope this information about “How to Use Auto 12-Volt Regulator for Solar Panel” is really helpful to you as well as other information related to Solar_Energy

Use Auto 12-Volt Regulator for Solar Panel Related

How to Use Auto 12-Volt Regulator for Solar Panel

Leave a Reply

Your email address will not be published. Required fields are marked *