Menu

Troubleshoot Air Conditioning in Honda CRV

Keeping / C in your Honda CRV in operation in summer with little troubleshooting. Problems with / C, as problem with compressor or blown fuse, are fairly easy to diagnose. Before taking his Honda CRV in store for what could become costly diagnosis and repair, there are some troubleshooting steps that can be run through its own.

Turn / C and fan with engine running. Check that dials and buttons are in good working order. If they are loose or difficult to move, you may need to replace them.

Troubleshoot Air Conditioning in Honda CRV

If blower fan does not start, fuse connected to fan may have blown, or fan itself may be faulty. Check fuse box, which is beneath trim to left of steering wheel. Look for blown fuses.

Read inside panel schematic on how to locate fuse corresponding to A/C system. If thin metal wire inside glass fuse is damaged or broken, replace it with another fuse of exact same amperage rating. Inspect A/C hoses for kinks or leaks.

few drops of refrigerant around connections is normal. If, however, there is large amount of oily residue on any of A/C components, you may need to replace them. If any of hoses are kinked, squeeze hose between your thumb and forefinger until kink has diminished.

If this does not resolve problem, you may have to replace hose in question. Start engine and open hood to examine two heater hoses near firewall. heater hoses are roughly same size as garden hose, and firewall is partition that divides passenger compartment and engine compartment of your car, which extends from just below windscreen to below engine.

Check temperature of hoses. One should be slightly cooler than other. If it is not cooler, you may have to replace valve control.

Turn A/C to coldest setting with engine running. Check under hood for magnetic clutch to turn over. magnetic clutch is attached to A/C compressor and you should be able to see and hear it as it begins to turn.

If magnetic clutch does not engage, system may be low on refrigerant and may need refill. Look for any leaks on compressor and ensure that drive belt is securely connected. excessively noisy compressor may signal cross-contaminated refrigerant, use of wrong type of compressor lubricant, or need for new compressor.

If magnetic clutch is receiving voltage but is not engaging compressor, clutch may be defective and may need to be replaced. If you notice leaks around compressor shaft seal, seal may need to be replaced.

We hope this information about How to Troubleshoot Air Conditioning in Honda CRV is really helpful to you as well as other information related to Air Conditioner

Troubleshoot Air Conditioning in Honda CRV Related

How to Troubleshoot Air Conditioning in Honda CRV

Leave a Reply

Your email address will not be published. Required fields are marked *