Repair Whirlpool Tub

If your hot tub is not working properly, you may have no idea of ​​how it should be repaired. With little knowledge and some common household tools that hot tub is just a few minutes that gives place to relax your day. Check to see if a bath will begin, and make sure the power is in the service panel.

This may seem rudimentary, but it is also a leading cause of why some tubs are not executed. In addition, retention drain for clogs if the water is slow to drain. Test the motor and pump.

Repair Whirlpool Tub

Make sure there are not corroded terminals or loose or broken wiring exposed. Clear blocked water intake if jets are not working, as this could also be indicator as to why tub is not running. Broken jets will have to be replaced.

Do you generally operate hardware at high temperature If so, you will need to make sure you have not tripped high limit reset switch. same action applies for water that is too cold. Reset switch if necessary.

You may also want to take this time to replace your heating element. Disconnect tub at its power source. Remove all screws that hold heater housing cover in its place, and then mark and disconnect element leads.

Set multimeter to resistance times 1 RX1 , and then clip each probe to terminals. If your meter does not read low ohms, then replace element by first draining water from tub. Disconnect all wires to heating element, switches and sensors that are necessary so that you can effortlessly remove element.

Take out used element, mounting plate and mounting gasket. Attach new element to mounting plate, install then and remount remaining parts. If leakage can be seen under unit, take close look at pump. Is your water level dropping too fast Do jets unevenly emit water or surge erratically If your answer is yes to either of those questions, it is time to get new pump union gasket.

Replacing pump union gasket is relatively simple. Check out your owner’s manual to determine replacement part number, size and device location. Unscrew fitting and carefully remove gasket.

Install new union gasket and then reattach fitting.

We hope this information about “How to Repair Whirlpool Tub” is really helpful to you as well as other information related to Bathtubs

Repair Whirlpool Tub Related:

How to Repair Whirlpool Tub

Leave a Reply

Your email address will not be published. Required fields are marked *