Menu

Repair Steelcase Chair’s Cylinder

Overtime, pneumatic gas cylinders in Steelcase office chairs begin to leak. Soon, lift mechanism stops working. good news is that when this occurs, there is no need to replace your chair.

It only takes about fifteen minutes and few common household tools to replace pneumatic gas cylinder in your office chair. model number of Steelcase chairs determines type of Steelcase pneumatic gas cylinder and bearing kit that you should order. Turn Steelcase chair upside down.

Repair Steelcase Chair’s Cylinder

Use flat-head screwdriver to pry off base retaining clip. Lift base off chair, i,e., part attached to wheels. Use screwdriver to take out bearing assembly and two golden-colored bearing washers on either side.

Lift out rubber cushion and bright zinc washer with screwdriver. Use screwdriver to pry out notched pneumatic cylinder retainer and large flat washer beneath it. Take out old pneumatic cylinder.

Discard all of parts that you have removed, other than chair base. Insert new pneumatic cylinder with long rod of cylinder pointing out of chair. Place large flat washer over pneumatic cylinder rod, followed by pneumatic cylinder retainer.

Slide 1-inch pipe over rod of pneumatic cylinder. Tap 1-inch pipe with hammer to seat pneumatic cylinder retainer firmly. Remove pipe.

Place large, bright zinc washer over rod, followed by rubber cushion, golden-colored bearing washer, bearing assembly, and another golden-colored bearing washer. Put chair base with wheels back on chair. Slide base retaining clip into place and use pair of needle-nose pliers to snap it into place.

We hope this information about “How to Repair Steelcase Chair’s Cylinder” is really helpful to you as well as other information related to Chairs

Repair Steelcase Chair’s Cylinder Related:

How to Repair Steelcase Chair’s Cylinder

Leave a Reply

Your email address will not be published. Required fields are marked *