Repair Bathroom Floor and Subfloor

Water damage in the bathroom can occur so slowly that weakens ground without anyone noticing. toilet that seeps slowly around wax ring or sink drain that has slow drip can do significant damage. It becomes spongy floor or floor covering begins to crack and lift.

toilet flange can oscillate when toilet is connected to ground begins to rot. This type of problem must be addressed immediately because the damage progress Remove all bathroom accessories and remove ground cover. Pay special attention to accessories and drains to remove accessories.

Repair Bathroom Floor and Subfloor

source of leak must be located and corrected to avoid damage to replacement subfloor and floor. Cut floor out along joist as close to walls as possible. Use old saw blade in circular saw when cutting out old flooring, embedded nails will ruin saw blades.

Remove subfloor in same manner. Replace subfloor and floor with materials of same thickness as original. Remember to cut openings for all drains and water supply lines before nailing subfloor and floor in place.

Reinstall fixtures and reconnect water supply lines and drains. Always use new flange and wax seal when reinstalling toilet. Replace washers and gaskets in drains before retightening.

Do not overtighten drain and water connections to avoid damaging washers and seals. Caulk around all fixtures after reinstalling. Replace floor covering.

Turn off water supply and drain as much water as possible from toilet. Remove toilet from bolts that attach it to floor flange and loosen water supply line from toilet. Lift up on toilet and place it in large pan to contain any water not removed.

Inspect floor flange for rust and damage. Test flooring around toilet flange with small screwdriver for softness. Check for water stains running underneath edge of floor covering.

Remove floor covering if water damage has spread. Locate floor joist on each side of toilet, mark and cut both floor and subfloor in center of joist. Mark straight line horizontally across floor in front and behind toilet.

Cut carefully with circular saw set to depth of floor. Use old saw blade because you will encounter nails. Remove section of floor and then cut subfloor in same manner.

We hope this information about “How to Repair Bathroom Floor and Subfloor” is really helpful to you as well as other information related to Bathroom

Repair Bathroom Floor and Subfloor Related

How to Repair Bathroom Floor and Subfloor

Leave a Reply

Your email address will not be published. Required fields are marked *