Menu

Recharge Air Conditioning with Freon in Toyota Tundra

Sometimes, if your air conditioning system is working properly, it adding refrigerant is all that is needed to correct problem of blowing hot air. You can use refill kit R134 car from your local automotive store to do this. In some areas, you may need to buy license refrigerant.

Look conditioner air lines for leaks and damage. Replace or repair damaged parts before proceeding to recharging. If desired, you can use leak detection kit.

Recharge Air Conditioning with Freon in Toyota Tundra

Find Low Pressure Side port connector. It is near firewall on most Toyota Tundra trucks. This location may vary in some Tundra trucks.

It will have yellow cap marked LOW. Take this cap off and put it in safe place. You will have to replace it later.

Turn on engine and set air conditioner to coldest setting. You also need to have it blowing as hard as possible. Check pressure in air conditioning system using automotive air conditioning pressure gauge, available at most automotive stores.

This allows you to get valid pressure reading. If pressure is above acceptable range, recharging system may cause explosion and you should take your Toyota Tundra to mechanic for service. Connect refrigerant according to kit directions.

Allow air conditioning system to empty can. You should check pressure often to make sure it stays out of dangerous levels. It can take as long as 10 minutes for can to fully empty.

Recheck pressure. If it is still below normal range, add more refrigerant. Make sure that you check pressure often after you begin new can to keep it out of dangerous level.

We hope this information about How to Recharge Air Conditioning with Freon in Toyota Tundra is really helpful to you as well as other information related to Air Conditioner

Recharge Air Conditioning with Freon in Toyota Tundra Related

How to Recharge Air Conditioning with Freon in Toyota Tundra