Menu

Recharge Air Conditioning with Freon in Mercury Villager

Air conditioning recharge itself in Mercury Villager is possible if it is compatible with refrigerant R134. Some models manufactured before 1995 may have to be adapted to accept R134 refrigerant instead of R12 refrigerant. Sometimes, you may have to take your van to professional if you need license to buy refrigerant in your area.

Inspect air conditioning system for damage or leaks. By doing this, keep your eyes open for port of low pressure side. This is close to firewall on passenger side of truck facing towards center of engine.

Recharge Air Conditioning with Freon in Mercury Villager

It has black cap on it. Remove cap. Turn on van and start air conditioner.

Turn it on highest fan speed and lowest temperature. Check pressure in system using automotive air conditioning pressure gauge. If it is below 25 psi, you need to add more refrigerant.

If it is above 25 psi, lack of pressure isn’t problem and you should have professional check it out. Hook up refrigerant refill kit to Low Pressure Side port. way you do this will vary depending on type of kit and manufacturer, so read and follow directions included in kit.

Continue to add refrigerant until pressure is between 25 and 45 psi. If pressure gets any higher than 45 psi, explosion could occur, causing serious injury or even death so it is important to check pressure often when you are recharging system.

We hope this information about How to Recharge Air Conditioning with Freon in Mercury Villager is really helpful to you as well as other information related to Air Conditioner

Recharge Air Conditioning with Freon in Mercury Villager Related:

How to Recharge Air Conditioning with Freon in Mercury Villager

Leave a Reply

Your email address will not be published. Required fields are marked *