Menu

Re-route Bathroom Plumbing

The good thing about bathroom remodeling is that often translates into increased value of your home that is greater than it actually costs remodeling. Whether you want more space or want new traffic pattern in the bathroom, one thing is inevitable – the need to relocate the pipes. Before starting the demolition of the accessories, make sure your new plan is viable.

Determine new settings to suit your bathroom drainage system of the existing house. While it is possible to move almost any big accessory, under the bathroom floor are supporting beams should not be cut in order to install new drains. The design of your new configuration, so that new drainage run parallel to the joists and between them.

Re-route Bathroom Plumbing

Determine fixture setbacks. Check your local building code first. If you are required to pull permit for bathroom remodel, you will probably have to adhere to setback measurements. This just means allowing adequate room on all sides of your major fixtures.

Follow standard code if local code is not available see Resources below . Provide future access panels. While sink plumbing is usually accessible in cabinet below and toilet plumbing requires only lifting toilet from floor flange, it’s different story for bathtub or shower plumbing.

Should there ever be problem with your bathtub or shower plumbing, only feasible access is often from adjoining room, hopefully in closet or inconspicuous place. If sidewall in bathroom is available, plan access panel there. Turn off water supply before you begin, this is usually located in utility room.

Some older homes have only meter shut off outside. Remove fixtures and disconnect water feeds and drains. Cap and seal all old water feeds.

You can crimp copper tubing or purchase special caps for PVC tubes. Install your new water feeds, bringing hot and cold water directly up from below, between studs. Avoid running feeds horizontally or drilling through studs.

Tie into old system if you have copper feeds or run new PEX tubing if you have compression port system, such as Manabloc.

We hope this information about “How to Re-route Bathroom Plumbing” is really helpful to you as well as other information related to Bathroom

Re-route Bathroom Plumbing Related:

How to Re-route Bathroom Plumbing

Leave a Reply

Your email address will not be published. Required fields are marked *